mobil kırma eleme ünitesi

UĞURMAK UTK Series Tertiary Impact Crushers are preferred at crushing for medium and low hardness, mostly at tertiary level and can be used as secondary crushers depending on the hardness and feeding size. It produces very fine aggregate which is required for asphalt and concrete production. The rotor can rotate in both directions. The direction of rotation is bi-directional, allowing product to be received in two different gradations without setting changes. In addition, it provides longer life since there will be bi-directional wear on rotor hammers. According to the design of the facility, they can be manufactured as mobile, with fixed steel legs, with fixed concrete legs, with fixed skid chassis.

Stock conveyors can be produced as radial type according to the location of the facility, land conditions and customer demand. The Belt Conveyor chassis is connected to the ground from the tail module with a fixed joint. High-strength steel construction feet made to support the weight of the intermediate modules and the drive module are attached to the axle located on the wheels. These wheels are preferred as filled wheels in order to be loose-proof. The gearbox is driven by a coupled motor. It is equipped with a special brake system to prevent movement due to environmental effects during operation or stopping. The center of rotation is the fixed hinge point in the tail module. It is provided to turn clockwise and counterclockwise by the angle allowed. In this way, the stock amount is much more than a fixed stock belt conveyor.

UĞURMAK brand Mechanical Stabilization Plant is used in the preparation of all kinds of mechanical materials used in road construction and airport runway construction. This mechanical material is obtained by mixing aggregate and sand of suitable size in the mechanical stabilization plant with a sufficient amount of water. Before applying asphalt, it is necessary to increase the bearing strength of the existing ground and eliminate the internal stresses, if any, against problems such as collapse orpitting. To achieve this, only mechanical material can be laid on the existing floor before asphalt application. This base layer, which will be laid before asphalt, must be suitable for compacting. Considering the 15-day sieve analysis results, the mixing ratios are determined according to the previous percentage rates. Foreign materials such as clay and silt should not be present in the mechanical material layer. Robust, clean aggregate should be used.

UĞURMAK CDK Series Primary Impact Crushers have a design that allows the rotor, two pendulum systems and wear plates to work in harmony. Thanks to this compatibility, it offers high performance and low operating costs. It can provide very high size reduction ratios in breaking not very hard and non-abrasive materials. Thanks to these advantages, they are preferred in primary crushing stage in crushing and screening plants. According to the design of the facility, they can be manufactured as mobile, with fixed steel legs, with fixed concrete legs, with fixed skid chassis. CDK consists of three main parts. Rotor, fixed lower body and opening top body. The upper body rotates around a hinge fixed to the lower body with the help of the hydraulic mechanism enough to expose the rotor and the internal parts..