NICOLAS INDUSTRIE

UĞURMAK CDK Series Primary Impact Crushers have a design that allows the rotor, two pendulum systems and wear plates to work in harmony. Thanks to this compatibility, it offers high performance and low operating costs. It can provide very high size reduction ratios in breaking not very hard and non-abrasive materials. Thanks to these advantages, they are preferred in primary crushing stage in crushing and screening plants. According to the design of the facility, they can be manufactured as mobile, with fixed steel legs, with fixed concrete legs, with fixed skid chassis. CDK consists of three main parts. Rotor, fixed lower body and opening top body. The upper body rotates around a hinge fixed to the lower body with the help of the hydraulic mechanism enough to expose the rotor and the internal parts..

UĞURMAK UDK Series Vertical Shaft Impact Crushers are preferred at the last stage of the crushing and screening process. They have a high production capacity. It successfully performs to break wet, moisty and sticky materials. Moreover, such fed materials get rid of some of the water in the body with the kinetic energy that emerges when it collides with the rotor rotating at high speed. Therefore, the end material is relatively drier. Thanks to these advantages, it is highly demanded for use in the production of sand and gravel necessary for concrete and asphalt production. Depending on the design of the facility, it can be manufactured as mobile, with fixed steel legs, with fixed skid chassis or with front feed.

Aşınmaya karşı uzun ömürlüdür. Güçlü ve dayanımlı gövde yapısıyla az bakımla uzun süre çalışma imkanı verir. Az enerji tüketir. Düşük kw değerinde yüksek kapasitede çalışır. Kolay ayarlanabilir hidrolik yapısıyla işçilik süresini azaltır.

Stock conveyors can be produced as radial type according to the location of the facility, land conditions and customer demand. The Belt Conveyor chassis is connected to the ground from the tail module with a fixed joint. High-strength steel construction feet made to support the weight of the intermediate modules and the drive module are attached to the axle located on the wheels. These wheels are preferred as filled wheels in order to be loose-proof. The gearbox is driven by a coupled motor. It is equipped with a special brake system to prevent movement due to environmental effects during operation or stopping. The center of rotation is the fixed hinge point in the tail module. It is provided to turn clockwise and counterclockwise by the angle allowed. In this way, the stock amount is much more than a fixed stock belt conveyor.